Ga naar hoofdinhoud
Beoordeeld met 3.5/5 op eKomi 81.39% positief · Totaal aantal reviews: 91888,2/10 op Kiyoh van 8.372 recensies, sinds het begin
Hoe recensies worden gecontroleerd

Zowel Kiyoh als eKomi nodigen klanten na een bestelling uit een recensie achter te laten. Kiyoh verklaart dat het recensies controleert op echtheid. De Kiyoh-score gaat over al onze recensies tot nu toe. De eKomi-score en het percentage positieve recensies gaan over de laatste 12 maanden; het totaal van eKomi telt alle eKomi-recensies tot nu toe.

42.0% KORTINGMET CRYPTOBetaal met crypto, bespaar 42.0% op bestellingen vanaf USD 100Tot 19 november. Verzendkosten niet inbegrepen. Plus 5 gratis zaden bij een bestelling boven € 100.Bekijk zaden

DLI calculator for cannabis

Work out the daily light integral your plants get from PPFD and light hours, or from your lamp wattage and tent size. See whether it suits the growth stage and what to change if it doesn't.

Loading calculator…

The calculators and tools on this site give estimates for general information only. They are not professional advice and come with no guarantee. Results depend on the values you enter and on your own growing conditions. Check your local laws before you grow. You use the tools at your own risk. See our Terms and Conditions.

How the DLI is calculated

DLI (mol/m²/day) = PPFD (µmol/m²/s) × hours of light × 3600 ÷ 1,000,000.

PPFD tells you how much light lands on the plants each second. DLI adds that up over the whole day, so it shows the effect of both brightness and day length. In flowering, photoperiod plants get a fixed 12-hour day, so the only way to raise DLI is more intensity.

For the lamp estimate we use typical efficiencies at the wall: LED 2.7, CMH 1.9, HPS 1.7 and CFL 0.9 µmol per joule, the same values as in our electricity cost calculator.

The ranges we use per stage:

  • Seedlings and cuttings: 10 to 20 mol/m²/day
  • Vegetative growth: 20 to 40 mol/m²/day
  • Flowering: 30 to 45 mol/m²/day
  • Flowering with added CO₂: 45 to 65 mol/m²/day

Research on cannabis and light intensity: Rodriguez-Morrison, Llewellyn and Zheng, Frontiers in Plant Science (2021).

Frequently asked questions

What is DLI?

Daily light integral is the total amount of usable light that lands on one square meter of canopy in a day, measured in moles of photons. It combines how bright the light is with how long it stays on.

What is the difference between PPFD and DLI?

PPFD is a snapshot: the light hitting the canopy each second. DLI is the daily total. A lamp at 500 µmol/m²/s for 18 hours gives about 32 mol/m²/day, and the same lamp for 12 hours gives about 22.

Which DLI should I aim for in each stage?

Seedlings and cuttings do well on 10 to 20 mol/m²/day. In vegetative growth aim for 20 to 40. In flowering, 30 to 45 suits most growers. With added CO₂ and good climate control, plants can use 45 to 65.

Can cannabis get too much light?

Yes. At very high levels the plant cannot use all the light unless you add CO₂, and the tops can bleach or show leaf burn. Raise the lamp or dim it, then check the leaves after a few days.

What light schedule works for autoflowers?

Autoflowers do not need 12 hours of dark to bloom, so many growers keep them on 18 or 20 hours of light from start to finish. That gives a higher DLI with the same lamp.

Use this tool on your site

Copy this code into your page to embed the calculator. The link under the code is optional and you can delete it. The calculator itself always shows a small credit line.

DLI calculator by Amsterdam Marijuana Seeds

Become a partner and get more free tools